记作业>英语词典>bluing翻译和用法

bluing

n.  烤蓝; 蓝色漂白剂;上蓝剂; 蓝化;烧蓝;模温过高而引起的绿色氧化膜

化学

COCA.46990

英英释义

noun

  • a process that makes something blue (or bluish)
      Synonym:blueing
    1. used to whiten laundry or hair or give it a bluish tinge
        Synonym:blueingblue

      双语例句

      • The production shows that the best bluing time in normal temperature is from 4 to 8 minutes and bluing film is bright and anti-corrosion capacity is at or higher than the specified state standard.
        生产实践表明,常温发蓝的最佳发蓝时间为4~8分钟,发蓝膜光亮,耐蚀达到并超过国家规定标准。
      • Study of Basic Bluing Processing
        关于碱性发兰工艺的分析
      • By experiment and further application, it has been proved that wastewater from bluing in electroplating plant could be treated by urea reduction, resulting in removal of NO-2 N more than 99.9% and quality of water discharged conforming to our national discharge standard.
        通过对发兰废水处理方法的研究和实践,提出尿素还原法处理发兰废水是可行的,废水中NO-2-N的去除率达99.9%以上,出水水质达到国家排放标准。
      • Adhesion, wear and corrosion resistance of the coatings obtained were compared with those of conventional bluing at room temperature.
        测量了发蓝膜的附着力、耐磨和耐蚀性,并与传统常温发蓝进行了对比。
      • In view of the weaknesses of conventional bluing at room temperature such as poor adhesion and wear resistance, a composite bluing process for spring parts at room temperature was advanced.
        传统的常温发蓝工艺存在着附着力和耐磨性差的缺点。研究了一种用于弹簧件的常温复合发蓝工艺。
      • Investigation on Bluing of Steel at Room Temperature In-Situ
        常温原位发蓝研究
      • Tapered bores for keyed hubs shall have a minimum of70% transfer of bluing ( surface contact) to the taper gage.
        键槽轮毂的锥孔应至少有70%的着色(表面接触)转移到锥度计上?
      • The paper introduces a new technology of bluing in normal temperature with characteristics of high efficiency, energy-saving and non-pollution.
        阐述了具有高效、节电、无污染等特点的常温发蓝新工艺。
      • Contrast between Bluing in Alkaline Media and Blackening at Room Temperature for Steel Parts
        钢铁零件热碱发蓝与常温发黑的应用对比
      • The causes of red exo-frost on bluing coating were analysed, which were higher content of main component in solution, more ferriferous oxide, smaller bluing tank volume, poor operation, repeated workpiece reworking, etc..
        分析了发蓝膜层出现红色挂霜的原因:溶液主要成分含量过高、铁氧化物过多、发蓝槽容量小、工艺操作不当、工件多次返修等。