记作业>英语词典>tangency翻译和用法

tangency

网络  切线连续; 接触; 相切; 切向参考; 切矢连续

复数:tangencies 

英英释义

noun

  • (electronics) a junction where things (as two electrical conductors) touch or are in physical contact
    1. they forget to solder the contacts
    Synonym:contact
  • the state of being tangent

    双语例句

    • The essence of arc joining is making the tangency of the arc and line or the arc and arc. The programmed Drawing method of arc joining based on AutoCAD secondary-development is studied in this article. The Visual LISP drawing program of arc joining is merited.
      圆弧连接的本质就是使圆弧与直线或圆弧与圆弧相切,在此研究了基于AutoCAD二次开发的圆弧连接程序化绘制方法,用VISUALLISP语言编程建立了圆弧连接通用绘图程序。
    • Taking the reform in curriculum system, content of courses and teaching method as our point of tangency;
      以课程体系、教学内容和教学方法的改革为切入点,大力加强传统专业的更新改造;
    • That would mean that everybody is holding that same portfolio of risky assets and nobody is different, they're only different in how what proportions they hold the risky the tangency portfolio.
      这就意味着每个人,都持有相同风险资产投资组合,每人都是一样的,他们唯一的不同在于-,他们所持有风险资产的比例-,也就是切线资产组合。
    • According to certain rules, points of tangency or intersection with obstacle area are selected as the key points to cell decomposition by sweeping the target area with a tangent that shifts length timely.
      变长切线法通过切线扫掠目标区域,按一定规则选取由切线与障碍区产生的切点或交点作为关键点来进行单元分解。
    • This is just as point of tangency of this dissertation.
      这正是本研究的切入点。
    • What is the tangency portfolio in this case?
      这个案例中的切线投资组合又是什么呢?
    • Tangency is controlled by the first two control points from a surface boundary, assuming that these points lie in one line.
      相切是由曲面边界的最初两个控制点控制的(假设这些点在一条线上)。
    • Emergency Solution to the Equipment Failure of Subnet Access Node in Tangency SDH Loop
      相切组网SDH子网接入点失效的应急方案
    • Given a NURBS curve, perturbation for control points is chosen and the LSM ( Least Square Method) is used to modify the geometric features such as position, tangency or curvature of the selected parametric point on the given curve.
      通过对NURBS曲线的控制顶点扰动,采用最小二乘法修改曲线上给定一点处的位置、切矢和曲率等几何特征,并讨论了多点几何特征同时修改的情况。
    • The exterior tangency points P1 and P4 mark the coordinates where the penumbral shadow first contacts ( partial eclipse begins) and last contacts ( partial eclipse ends) Earth's surface.
      表面接触点P1和P4所处的坐标位置为第一次接触半影区和最后一次接触。